The mixer is mainly composed of a barrel, an upper structure, a lower structure, a rotating mechanism, a swinging mechanism and electrical equipment. It has good adjustability and wide adaptability. The thickness of the material layer, the moving speed in the machine and the entire amplitude can be adjusted steplessly. It causes relatively little damage to the surface of the material and can be used to dry fragile materials. When the material particles are irregular, it will not affect the working effect. The two-dimensional mixer adopts a fully enclosed structure to effectively prevent cross-infection between materials and outside air. The working environment is clean. Dust and other residues must be removed in time during use. The discharge port must be tidied up to avoid affecting the normal operation of the machine. operation.
The barrel and all exposed parts of the mixer are made of stainless steel, and the barrel is completely welded inside and outside. The internal and external polished operating table is made of non-slip square plates, the equipment bracket is covered with carbon steel spray paint, the rotating mechanism is located on the upper frame, and the gearbox uses a cycloidal pinwheel reducer. When working, the reducer drives the drive shaft through the sprocket and chain, and then rotates the barrel through the drive wheel. The swing mechanism is located in the lower frame, and the transmission uses a cycloidal pinwheel reducer or a worm gear reducer. When working, the motor drives to the reducer through the pulley or sprocket, and then swings the upper structure through the double-link assembly, so that the barrel swings at a certain angle.
When the mixer is operating, under the action of the two layers of rotating organization and swinging organization, the charging cylinder rotates and swings at the same time, so that the materials in the cylinder can be fully mixed. The mixing time of each batch is about 15-20 minutes, and the materials in the cylinder are fully and evenly mixed. The equipment can be equipped with an automatic vacuum feeder and interface to facilitate loading and shorten operation time.
